Rod Tube Kit (RTK)
Assembly
Instructions
If You Have The RTL ( Kit w/ TUBE LINER)
Click Here
The actual assembly of the rod tube kits is
quite simple....
The kit Does Not Include Tubing. PVC or ABS tubing is available almost everywhere.
1. Cut
your tubing one inch longer than the longest section of your fly rod.
2. Slip
the Cordura Sleeve on over the tubing starting with the zippered end. It may be
tight with the liner attached but it will fit.
3. Pull
the top of the Cordura Sleeve until the zipper is just barely above the end of
the tubing.
4. Put
the foam insert inside the zippered cap, foam end towards the PVC and zip.
5. Cut
bottom of Cordura Sleeve about 1” longer than the tubing and tuck excess
inside tube.
6. Before
gluing, place Rubber Bottom Cap on bottom of tube to insure that everything fits
correctly.
7.
If all is okay, remove Rubber Bottom Cap, put PVC Pipe Cement or similar glue on inside sides of rubber
cap and replace on tube and let dry before putting rod into tube!
Easy, Simple, Done!
Return
To Rod Tub Kit Page: Click Here
Stone Creek, Ltd.